Industrilink provides extensive experience into the development of electrical- and control systems involving demanding electrical- and control functions.
We have been participating in several development projects, typically assisting with tasks like creating Functional Design Specifications (FDS) for the product to be developed. Other tasks might be the verification of possible solutions and selection of components and systems to be used.
We have vast knowledge of various marine and offshore applications, e.g. permanent magnet active heave compensated winches, pumps, personnel winches, top drives, tunnel boring machines, hydro power plants and many more.
To be the preferred supplier of development competence, Industrilink is striving to exceed at every available alternative to determine the best possible solution for our customers. Our focus is on simplicity, reliability and accuracy, with features to create a versatile system exceeding customer expectations.
Industrilink has vast experience with electrical- and control system engineering over a broad range from a straight forward motor starter to complex offshore drilling systems.
Our engineers have been involved in electrical and control system engineering all the way back from the world’s first electrical drilling drive system and the world’s first Active Heave Compensated drawworks. We provide systems tailor-made for our customers’ applications, while employing accurate, high performance motion control components.
During the engineering phase of a project, our engineers assist with ensuring that the product fulfills the technical specification, creating the required drawings and documents for production and other basic documentation to manufacture the product.
Our engineers are accustomed to standards and rules such as IEC, EMC, DNV/ABS and the EC Machinery Directive ensuring that the finished products meet expectations.
Industrilink can assist the customer in all phases of an electrical- and control system production, monitoring the production closely to ensure compliance with manufacturing documentation.
At the other hand Industrilink can deliver electrical- and control systems as finished products, ready for installation at the customer’s premises. In this case, the manufacturing of our solutions is done by our partners either domestic or abroad, depending on the most expedient solution and production capacity.
We are very satisfied with our production partners abroad, delivering the highest quality products at a reduced cost and with short delivery time.
Manufacturing is done according to relevant IEC regulations and national codes for onshore, marine or offshore applications.
Proper testing at the manufacturing facility of all electrical- and control systems is crucial for successive use of commissioning time. A system that is properly tested, allows the commissioning to proceed swiftly forward.
Industrilink can assist customers with testing of electrical- and control systems at the manufacturing facility. Testing and verification is done according to an approved test procedure, applicable standards, national regulations and other specifications that are valid for the delivery.
Documentation of the test results is done in subsequent test reports and punch lists.
Industrilink can deliver a complete documentation package of electrical- and control system or assist our customers in the documentation of electrical and control applications. The documentation is created by our engineers, utilizing their thorough understanding of design, technology and application.
We are familiar with documentation deliveries according to standards such as NS5820 and DNV rules and regulations.
Typical documentation delivered:
- Supplier master document list
- Functional design specification
- Single line diagrams
- Wiring diagrams
- Termination diagrams
- Technical datasheets
- Test procedure
- Test reports
- Installation instructions
- Operational instructions
- Maintenance instructions
- Transport, storage and preservation instructions.